Hydraulic Cylinder Repair in Wichita Falls, TX
Norwood Machine repairs and rebuilds hydraulic cylinders: teardown, inspection, reseal, rebuild, and test. A leaking, scored, or bent cylinder gets torn down, measured, and put back into service. When a rod or barrel is damaged, we machine or replace it rather than sending you to buy a whole new cylinder.
What we handle
- Leaking cylinders that need reseal
- Scored or pitted rods
- Bent or damaged rods
- Worn or damaged barrels
- Full teardown, rebuild, and test
- Cylinders off loaders, farm and construction equipment, trucks, and trailers
Size and capacity
| Max bore we service | Call to confirm |
|---|---|
| Max stroke we service | Call to confirm |
| Rod repair vs replacement | Call to confirm |
Call the shop to confirm capacity for your specific job.
Our rebuild process
- 1
Teardown
We disassemble the cylinder and clean every part.
- 2
Inspection
We measure the rod, barrel, and glands and identify what failed.
- 3
Report
We tell you what it needs and what it costs before any work starts.
- 4
Repair
We reseal, and machine or replace the rod or barrel as needed.
- 5
Reassembly
We rebuild the cylinder with new seals.
- 6
Test
We test it before it goes back to you.
Before
After
How it works
- 1 Bring the cylinder in, or send a photo of the leak or damage if it is still on the machine.
- 2 We tear it down, measure it, and tell you what it needs.
- 3 You approve the plan and the cost.
- 4 We reseal, machine or replace the rod or barrel, and rebuild it.
- 5 We test it, and you pick it up ready to run.
Turnaround
Lead time depends on parts and what the cylinder needs. Call the shop for current turnaround on your cylinder.
What to bring
Bring the whole cylinder if you can. If it is still on the machine and you are not sure it is the cylinder, send a photo of the leak or the damage and we will help you figure it out.
Not sure what you have got? Text us a photo.
Send a picture of the part or the machine to (940) 767-1224 and we will tell you if we can fix it and roughly what it takes. No charge to ask.
Text (940) 767-1224Common Questions
Can you save a scored rod, or does it need replacing?
Sometimes we can rechrome or repair it, sometimes it needs replacing. We measure it and tell you.
Do you test the cylinder before I get it back?
Yes. Every rebuild gets tested before it leaves.
What if I do not know the brand of the cylinder?
That is fine. We work from the cylinder itself, not a part number.
Can you rebuild a cylinder you did not build?
Yes. We rebuild cylinders off all kinds of equipment.
Related services
Broke down? Call the shop.
Monday to Friday, 7:30 AM to 5:00 PM.
You will get a machinist on the phone, not a call center.
Not sure what you have got? Send a picture. No charge to ask.